Colibri II / Flarm Mobile power and data interface is a special unit that converts 12V to 5V power supply for the Colibri II / Flarm Mobile. It also converts TTL levels of serial communication to RS232 levels. Maximum input voltage is 24V.
The unit has two plugs. On one side there is a standard USB A connector. Use the included USB cable to connect the Colibri II / Flarm Mobile on this side. On the other side is an RJ45 plug. This plug is a standard IGC 6-pin connector.
Colibri II - PC interaction
Task declaration transfer ( LXe, SeeYou...)
Power Colibri II or Flarm Mobile from glider network and NMEA output
Pins by numbers:
1 = + 12 V (red external wire)
2,3 = not used
4 = data out (RS232)
5 = data in - input (RS232)
6 = GND (blue external wire)